Description
Nu-Lustre 57 Epoxy for Wood and Concrete
Product Description:
Nu-Lustre 57 UV-resistant
Epoxy for Wood and Concrete:
Nu-Lustre 57 (UV-resistant) is a high-gloss epoxy finish for wood and cement. A single coat of Nu-Lustre 57 is equivalent to 57 coats of varnish. NU-LUSTRE 57 is resistant to sun rays, remaining clear while other epoxies tend to yellow. It can be applied to wooden tables and furniture (indoors and outdoors), concrete countertops, ceramic, stone, and craft projects made with newspaper, magazines, photographs, leather, dried flowers, seashells, and many other items. Nu-Lustre 57 wood and concrete epoxy is ideal for outdoor applications, such as boats, paddles, fishing rods, and signs.
Instructions:
The surface to be worked on must be clean and dry, free of any dirt, wax, grease, and oil. Measure one part resin and one part hardener into separate containers. Vigorously mix each of the two components individually for approximately 2 minutes. Then, combine the contents of each into a single container. Mix again for 1 minute and pour immediately. Bubbles that form on the surface can be broken by blowing on them or by using a hairdryer or a propane torch. Allow to dry for 24 hours at 20 to 25°C, and humidity below 50%.
Available in 946 ml and 3.78 liter sizes
Summary of features:
- High-Gloss Finish
- One coat equals 57 coats of varnish
- Protects surfaces from water and alcohol
- Non-yellowing, remains virtually clear
- Covers approximately 10 sq. ft./liter or 40 sq. ft./gallon
- Epoxy applied by pouring onto the surface and spreading with a squeegee
- Tool cleaning: Epoxy Thinner
- Available sizes: 946 ml and 3.78 liters
Drying
24 h between coats
Coverage
10 sq. ft. per liter
Mixing Ratio
1:1
Resistant to
UV rays
How to apply
Learn how to apply Nu-Lustre 55 epoxy with our video capsules
How to make an epoxy-coated wooden table 1:58
See how to apply Nu-Lustre 55 epoxy to a wooden table.
How to apply:
The surface to be worked on must be clean and dry, free of any dirt, wax, grease, and oil. Measure one part resin and one part hardener into separate containers. Mix vigorously for approximately 2 minutes. Then combine the contents of each into a single container. Mix again for 1 minute and pour immediately. Bubbles that form on the surface can be broken by blowing on them or by using a propane torch. Allow to dry for 24 hours at 20 to 25°C, and humidity below 50%. This product can be colored using universal dye.
There are no reviews yet.