Description
Sansin Pressure Plus Pressure-Treated Wood Protector
Pressure Plus makes your pressure-treated wood look beautiful and improves its dimensional stability by significantly reducing moisture absorption during wet weather. A single coat provides long-lasting beauty and performance for your pressure-treated decks or fences.
PRESSURE PLUS
Transforms green pressure-treated wood into a natural wood shade or enhances the natural shade of brown pressure-treated wood.
PRESSURE PLUS LIGHT
Transforms green pressure-treated wood into a natural wood shade or maintains the natural shade of brown pressure-treated wood.
PRESSURE PLUS GREY
Transforms brown or green pressure-treated wood into a durable grey shade and enhances grey pressure-treated wood.
Advantages
Gallon size
For pressure-treated wood or cedar
3 colors available
1 coat
Transforms the green color of pressure-treated wood into a beautiful natural wood shade
Enhances the natural shade of pressure-treated wood
Easy 1-step application
VOC compliant
Advantages
Eco-friendly
Translucent
Ideal for new or existing pressure-treated wood surfaces
Deep protection
Reduces water absorption
Reduces wood swelling
Water-repellent, breathable
UV resistant
Drying time
12h – 24h between coats
Coverage
250 – 350 sq. ft. per gallon
Number of coats
1 – 2 coats
Water-repellent protective coating
UV protection
Colors
* Colors displayed may vary depending on screen, wood grain, texture, porosity, as well as preparation and application method. We encourage you to test on a small surface beforehand to ensure the accuracy of the desired color.
How to apply
Pressure Plus makes your pressure-treated wood look beautiful and improves its dimensional stability by significantly reducing moisture absorption during wet weather. A single coat provides long-lasting beauty and performance for your pressure-treated decks or fences.
PREPARATION
- Inspect wood surfaces for defects and make repairs as necessary.
- Use the appropriate cleaner: Sansin Wood Cleaner and/or clean the surface with clear water using a pressure washer of at least 3,000 PSI. Be careful to avoid eroding the surface.
- For best results and a smooth surface, sand the surface using an orbital sander and 60-80 grit sandpaper.
- Complete cleaning using a pressure washer, vacuum, or compressed air. The surface must be clean and free of dust, dirt, grease, wax, or other existing coatings.
APPLICATION METHODS
- Always apply a generous coat to the surface and allow it to penetrate to the point of saturation.
- By dipping
- By brush
- By submersion
- Sprayer – hand or power spray (low pressure or airless)
DIRECTIONS FOR USE
- Stir well before and during application.
- Test the product on a small area to ensure proper penetration and color.
- Apply in ideal temperature and humidity conditions: 21°C (70°F) and approximately 50% relative humidity.
- Do not apply when precipitation is forecast or if there is a risk of frost.
- Saturate the wood surface (5-6 wet mils).
- Back-brush to spread evenly and eliminate marks.
- Do not apply to wood if it is hot to the touch.
- Constantly monitor the surface; wipe off any excess and back-brush.
- Always read the instructions before starting any project.
There are no reviews yet.